+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: KC868-HxB series Smart Controller (https://www.kincony.com/forum/forumdisplay.php?fid=2)
+--- Thread: Control defaults to TCP after power cut (/showthread.php?tid=5526)
Control defaults to TCP after power cut - Steve@ctrl - 04-12-2024
Hi there
I have an issues with the KC868-Server unit. The unit is set to MQTT work mode, but sometimes after a power cut the controller reverts back to TCP mode. How can I set it to always start in MQTT mode?
RE: Control defaults to TCP after power cut - admin - 04-12-2024
what's your firmware version?
RE: Control defaults to TCP after power cut - Steve@ctrl - 04-12-2024
Ill update the firmware for this device and test again. Which firmware is the correct version for the KC868-Server unit, is it the 32BS?
RE: Control defaults to TCP after power cut - admin - 04-12-2024
i don't understand which controller you are using? KC868-Server or KC868-H32BS?