KC868 server - Printable Version +- Smart Home Automation Forum (https://www.kincony.com/forum) +-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1) +--- Forum: KC868-Server Raspberry Pi4 local server (https://www.kincony.com/forum/forumdisplay.php?fid=17) +--- Thread: KC868 server (/showthread.php?tid=5743) |
KC868 server - fdcemb5 - 05-14-2024 if I connect DS18B20/DHT11/21 Temperature and humidity sensor to these pins, how do I make it appear in Home Assistant since I cannot write Arduino code on KC868 server GPIO-1: GPIO4 GPIO-2: GPIO5 GPIO-3: GPIO18 GPIO-4: GPIO19 RE: KC868 server - admin - 05-14-2024 you can config by esphome, these gpios manager by ESP32. RE: KC868 server - fdcemb5 - 05-15-2024 Kindly point to me to how this is achieved RE: KC868 server - admin - 05-15-2024 here is video tour about it: https://www.kincony.com/forum/showthread.php?tid=1826 |