+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: KC868-A series and Uair Smart Controller (https://www.kincony.com/forum/forumdisplay.php?fid=6)
+--- Thread: 1wire stopped working - KC868-A8 (/showthread.php?tid=5991)
1wire stopped working - KC868-A8 - deanfourie - 06-28-2024
Running esphome, lastest version, I have 4 of these board and only 1 has the issue.
No sensors found on the KC868-A8 on 1wire bus.
Any ideas?
Esphome config.
PHP Code:
one_wire:
- platform: gpio
pin: GPIO14
sensor:
- platform: dallas_temp
address: 0x950121128170a628
name: "Temp"
The log,
PHP Code:
[18:36:35][C][logger:185]: Logger:
[18:36:35][C][logger:186]: Level: DEBUG
[18:36:35][C][logger:188]: Log Baud Rate: 115200
[18:36:35][C][logger:189]: Hardware UART: UART0
[18:36:35][C][i2c.arduino:071]: I2C Bus:
[18:36:35][C][i2c.arduino:072]: SDA Pin: GPIO4
[18:36:35][C][i2c.arduino:073]: SCL Pin: GPIO5
[18:36:35][C][i2c.arduino:074]: Frequency: 50000 Hz
[18:36:35][C][i2c.arduino:086]: Recovery: bus successfully recovered
[18:36:35][I][i2c.arduino:096]: Results from i2c bus scan:
[18:36:35][I][i2c.arduino:102]: Found i2c device at address 0x22
[18:36:35][I][i2c.arduino:102]: Found i2c device at address 0x24
[18:36:35][C][gpio.one_wire:020]: GPIO 1-wire bus:
[18:36:35][C][gpio.one_wire:021]: Pin: GPIO14
[18:36:35][W][gpio.one_wire:078]: Found no devices!
RE: 1wire stopped working - KC868-A8 - admin - 06-28-2024
ESPHome updated 1-wire component, how to solve , see this link:
https://www.kincony.com/forum/showthread.php?tid=5939
RE: 1wire stopped working - KC868-A8 - deanfourie - 06-28-2024
(06-28-2024, 09:12 AM)admin Wrote: ESPHome updated 1-wire component, how to solve , see this link:
https://www.kincony.com/forum/showthread.php?tid=5939
Strange that the others are working fine, just not this one.
RE: 1wire stopped working - KC868-A8 - admin - 06-28-2024
update new yaml for a testing.
RE: 1wire stopped working - KC868-A8 - deanfourie - 06-29-2024
But my devices dont have internet connection
RE: 1wire stopped working - KC868-A8 - admin - 06-29-2024
update yaml in locally.
RE: 1wire stopped working - KC868-A8 - deanfourie - 06-29-2024
Sorry I dont understand.
RE: 1wire stopped working - KC868-A8 - admin - 06-29-2024
download firmware , such as by ESPHome, not need internet.