+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-AIO (https://www.kincony.com/forum/forumdisplay.php?fid=46)
+--- Thread: KC868-AIO LOXONE (/showthread.php?tid=6202)
KC868-AIO LOXONE - vosn1992 - 07-25-2024
Hi ,
i am trying to integrate my KC868-AIO into my loxone system .
i am new to this so i am having some problems.
i have done this so far :
pc and Kincony AIO are connected to the same acces point.
i can acces the AIO tru ESPhome .
when i configure the AIO there i can find the AIO in my wireless network
i was able to connect with the download tool so the firmware V2 could be installed but there i get stuck
the download is succesful
but then i can not do anything .
if i use the scan device tool i can not find the kincony
and the wireless signal of the kincony is gone until i re install it with the esphome "install for first use".
i am sure i am making some silly fault but unexperienced me is stuck at the moment
RE: KC868-AIO LOXONE - admin - 07-25-2024
1. the newest KCS firmware is v2.2.2, here is download link:
https://www.kincony.com/forum/showthread.php?tid=3791
2. when you download, your address is wrong, not "0x10000" , it should be"0x0"
RE: KC868-AIO LOXONE - vosn1992 - 07-26-2024
thanks ,
i re uploaded V2.2 into my unit on adress 0x0 .
but still i find no way to connect trough eternet or wifi .
what i tried so far :
i made my computer ip static in the same range as the AIO so 192.168.1.101
i used the scan device list but when hitting scan no results
AIO is connected with ethernet to a switch pc is connected to the same switch
also pc and AIO are connected trough usb
i also tried to reset ESP32 GPIO0 (am i right to assume thats the "download" button , the top one next to the usb C input) by holding to 10+ seconds but no wifi pops up
RE: KC868-AIO LOXONE - admin - 07-26-2024
1. after download need re power on of board.
2. KC868-AIO and your PC should connect to same router.
how to use KCS v2, here is online guide: https://www.kincony.com/esp32-kcsv2-firmware.html