+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-M16 / M1 / MB / M30 (https://www.kincony.com/forum/forumdisplay.php?fid=50)
+--- Thread: M16 Incorrect current reading (/showthread.php?tid=7112)
M16 Incorrect current reading - salvolivigni - 11-23-2024
Hi Admin, I recently purchased the M16 and 13 SCT013 board, I configured everything with esphome, so far everything is ok. But when I go to read the values of the specific probes, comparing them for example with a PZEM 0-16, I have values in watts very far from the real absorption, I also did a comparison with a clamp meter, and unfortunately the M16 probes all read values much higher than reality. For the voltage I solved it by modifying the file #define SENSITIVITY 525.0f, and now the voltage is correct, but unfortunately for the wattage I can't find a solution, can you help me?
RE: M16 Incorrect current reading - admin - 11-24-2024
First, compare the current values. If they are not normal, they need to be calibrated in the ESPHome YAML file.