+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-A8 (https://www.kincony.com/forum/forumdisplay.php?fid=23)
+--- Thread: Hardware issues (/showthread.php?tid=7149)
Hardware issues - ogo - 11-29-2024
Hello,
I bought a KC868-A8 a while ago that I've been using to test things and learn. Today I finally wanted to configure it properly to controls some lights. I have two issues
- Output 3 and 4 don't work: when I enable the outputs via home assistant or KCS, the LEDs for the outputs don't turn on, and I can't hear the click on the relay.
- When activating output 8, outputs 5, 6, and 7 are also activated: When I activate output 8 via home assistant or KCS, the LEDs of outputs 5, 6, 7, 8 turn on, even though those relays aren't active.
Things I've done so far:
- Remove everything from home assistant and install it again
- Disconnect everything from the board
- Flashed KCS instead of ESPHome
- Factory reset using KCS
- Flashed ESPHome again
Nothing seems to fix it, so I can only think it's a hardware issue, not software. The board version is 1.6, and it also has a 433 MHz receiver/transmitter.
Any ideas?
RE: Hardware issues - admin - 11-29-2024
what KCS firmware version you are using? Take a screen photo of KCS INDEX webpage.
can you take a video of your problem, send to whatsapp number: +86-15381188302