Smart Home Automation Forum
KC868-A16 need to power cycle - Printable Version

+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: KC868-A series and Uair Smart Controller (https://www.kincony.com/forum/forumdisplay.php?fid=6)
+--- Thread: KC868-A16 need to power cycle (/showthread.php?tid=7253)



KC868-A16 need to power cycle - soulmf - 12-22-2024

Hi there, i have just installed latest KCS firmware (V2.2.8) on my KC868-A16 and i noticed that besides the ntp time offset problem, after soft restarting the board the lan does not work. The only solution is to power cycle the board. On the wifi, connection re-establishes normally. I guess it's a software issue besause ESPHOME reboots and re-establishes on LAN successfully. Plz consider fixing in on next update. Thank you in advance![url=https://www.kincony.com/forum/showthread.php?tid=7077][/url]


RE: KC868-A16 need to power cycle - admin - 12-22-2024

after download firmware, you need re power on of your board.


RE: KC868-A16 need to power cycle - soulmf - 12-22-2024

(Yesterday, 10:58 AM)admin Wrote: after download firmware, you need re power on of your board.

I know that. It needs to be done each time i soft reboot the board.


RE: KC868-A16 need to power cycle - admin - 12-22-2024

about LAN8720, need hardware reboot.


RE: KC868-A16 need to power cycle - soulmf - 12-22-2024

So how that does not affect ESPHOME firmware but only KCS?


RE: KC868-A16 need to power cycle - admin - 12-22-2024

do you means firmware download by ESPHome not need to hardware re power on. But download by KCS firmware, MUST need re power on of board?
Yes, That's true. ESPHome as same as arduino IDE, after download will auto reset hardware. But ESP32 download tool can't do that.