+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-A4 (https://www.kincony.com/forum/forumdisplay.php?fid=21)
+--- Thread: KC868-A4 - DHT 22 (/showthread.php?tid=7893)
KC868-A4 - DHT 22 - ariffakil - 04-02-2025
Dear sir .,
i like to know to which in i hvae to Connect DHT 22 or 11 in KC-868 -A4 1.2.5 borad , i used pin 13 but its cant able to reade
RE: KC868-A4 - DHT 22 - admin - 04-02-2025
do you using KCS v2 firmware ? or you config by ESPHome? or write your own arduino IDE code?
please write your question in details, so that can help you.
RE: KC868-A4 - DHT 22 - ariffakil - 04-02-2025
i am using my own aruduino IDE code
RE: KC868-A4 - DHT 22 - admin - 04-02-2025
GPIO13 is OK for DHT22. KC868-A4 board already include pull up resistance, make sure your DHT22 without pull up resistance. you can take a photo of your sensor. another way, you can download KCS v2 firmware , set DHT22 to use, test the hardware whether work well. if KCS firmware work well, then you should check your arduino code.
RE: KC868-A4 - DHT 22 - ariffakil - 04-02-2025
we are using GHT 22 and DHT without any pullup resistenace , Can i use another PIn number , please find the picture of sensor
we are using DHT 22 and DHT without any pullup resistenace , Can i use another Pin number , please find the picture of sensor also i attched code any mistakes please let me know
RE: KC868-A4 - DHT 22 - admin - 04-02-2025
maybe you should connect with 5V for your DHT22 sensor, NOT by 3.3v power.
please test by KCS v2 firmware firstly.
here is KCS v2 online guide: https://www.kincony.com/esp32-kcsv2-firmware.html
RE: KC868-A4 - DHT 22 - twostar - 04-02-2025
To confirm the above, most DHT22's won't run off the 3.3V output on the board so you have to take a 5V tap off the 433MHz connector. There's another thread somewhere that discusses this.
RE: KC868-A4 - DHT 22 - admin - 04-02-2025
so i have told you, let KCS firmware to confirm firstly.