+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-M16 / M1 / MB / M30 (https://www.kincony.com/forum/forumdisplay.php?fid=50)
+--- Thread: M30 CT ratio (/showthread.php?tid=7911)
M30 CT ratio - Linus68 - 04-07-2025
Hi
I need to use other CT with different CT ratio.
In ESPHome I can Change IT.
But need IT in the Webpage (stand alone use).
IS IT planed to integrate IT in the UI?
Or IS the source Code available?
BR
Linus
RE: M30 CT ratio - admin - 04-08-2025
if you use M16v2 or M30 board, just chose 2000:1 CT clamp sensor, it according to PCB hardware design.
RE: M30 CT ratio - Linus68 - 04-08-2025
Hi
I know the HW Design, and can also modify IT.
So the question IS can the SW BE Made more universal.
Would bei interessted for more customer
BR
Linus
RE: M30 CT ratio - admin - 04-08-2025
not only change the software will suitable for different CT sensors.
RE: M30 CT ratio - Linus68 - 04-08-2025
Why Not
IT IS Just the Parameter Like in ESPHome
Have CT 600A/40mA.
This IS compatible with HW.
Only SW Not.
So IT would bei a benefit for the M30 HW to have a universal SW
RE: M30 CT ratio - Linus68 - 04-16-2025
Hi
are there any news available?