+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: DIY Project (https://www.kincony.com/forum/forumdisplay.php?fid=3)
+--- Thread: kc868-server16 (/showthread.php?tid=8317)
kc868-server16 - fdcemb5 - 07-13-2025
My KC868-server16 refused to boot, and it is just blinking as shown in the video. I have inserted the SD card into the standalone Raspberry Pi 4 module, and it booted. I am wondering what to do next. I have tried several times to reboot without success.
RE: kc868-server16 - admin - 07-13-2025
you can try to remove CM4 from bottom pcb, re plugin again, make sure have a good contact.
RE: kc868-server16 - fdcemb5 - 07-14-2025
(07-13-2025, 11:46 PM)admin Wrote: you can try to remove CM4 from bottom pcb, re plugin again, make sure have a good contact.
I have removed CM4 from the bottom PCB and re plug again, it is the same result. It is just blinking without booting. I guess, it is a hardware failure
RE: kc868-server16 - admin - 07-14-2025
do you means after installed home assistant firmware to SD card. after reboot , can't login? please check ip of CM4 in your router, use IP address to login, not use by domain.