M1-Home assistant.txt (Size: 865 bytes / Downloads: 203)
esphome:
name: m1
platform: ESP32
board: esp32dev
uart:
- id: uart_bus
tx_pin: GPIO13
rx_pin: GPIO14
baud_rate: 9600
stop_bits: 1
# Enable logging
logger:
# Enable Home Assistant API
api:
# Example configuration entry
ethernet:
type: LAN8720
mdc_pin: GPIO23
mdio_pin: GPIO18
clk_mode: GPIO17_OUT
phy_addr: 0
sensor:
- platform: bl0942
uart_id: uart_bus
update_interval: 3s
voltage:
name: 'M1 Voltage'
current:
name: 'M1 Current'
filters:
multiply: 0.1965
power:
name: 'M1 Power'
energy:
name: 'M1 Energy'
frequency:
name: "M1 Frequency"
accuracy_decimals: 2
switch:
- platform: gpio
pin: 33
name: "M1-relay"
binary_sensor:
- platform: gpio
pin: 32
name: "M1-sensor-DI"