Smart Home Automation Forum › Technical Support › KC868-Uair
K868-Uair proper GPIO assignation ?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
K868-Uair proper GPIO assignation ?
vincen Offline
Junior Member
**
Posts: 30
Threads: 7
Joined: Feb 2022
Reputation: 0
#11
03-14-2022, 08:22 AM
(03-13-2022, 01:37 AM)admin Wrote: i think you need to check software, hardware is no problem, here is some our demo images.

Did you get a look at code I use ? You'll see it's good and it's clearly device that has a wiring problem on board !!
Website Find
Reply
admin Offline
Administrator
*******
Posts: 6,639
Threads: 844
Joined: Oct 2020
Reputation: 162
#12
03-14-2022, 11:18 AM
your code have problem, i already told you the reason and give you the correct code, just use it!
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://shop.kincony.com
Find
Reply
admin Offline
Administrator
*******
Posts: 6,639
Threads: 844
Joined: Oct 2020
Reputation: 162
#13
03-14-2022, 11:19 AM
GPIO33 use for 1 LED !!!
GPIO32 use for 4 LED

you have define all is "4"! Do you understand?
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://shop.kincony.com
Find
Reply
vincen Offline
Junior Member
**
Posts: 30
Threads: 7
Joined: Feb 2022
Reputation: 0
#14
03-15-2022, 08:13 AM
(03-14-2022, 11:19 AM)admin Wrote: GPIO33 use for 1 LED !!!
GPIO32 use for 4 LED
you have define all is "4"!  Do you understand?

Yep but it doesn't change the problem as it's a bad layout problem in device itself !! When the bar is on one of the ring led doesn't follow anymore the ring !! Default of product design, sorry to say Sad
Website Find
Reply


Forum Jump:


Users browsing this thread: