AutoSteps staircase lighting controller

[HansBagieta]

Hello
I would like to build an AutoSteps staircase lighting controller that allows automatic control of the staircase lighting
in the staircase. Which gives the possibility of obtaining a decorative visual effect consisting of smooth
brightening and extinguishing of the stair lighting.
I would like the device to be configured using four buttons on the front (left/right/confirm/cancel - long press to return to the main screen) of the device and an OLED display, thanks to which I could change the staircase controller settings. It would be nice if the device allowed independent control of LED light sources up to 24 V DC. Do I need anything else besides the KC868-AP ESP32 DC12/24V LED Dimmer to control the brightness of the lights?
Control with a PWM signal:
• LED bulb, LED strip, LED module, LED strips, LED eyes

To be able to connect a signal from motion sensors at the beginning and end of the stairs, which would activate animations controlling the brightness of the connected light sources.

Can I also add an RTC time module?

Is it possible to make such a controller?
Best regards

[admin]

KC868-AP have 16 channel 12/24v DC output use for LED lamp. it also have many digital input ports, you can download KCS firmware, set by IFTTT. or you can config it automation by ESPHome. Also support you write your own arduino code for this project.