Posts: 6,254
Threads: 806
Joined: Oct 2020
Reputation:
151
you can create second IFTTT command for "HOLD ON". just create multi IFTTT command is ok.
Posts: 23
Threads: 2
Joined: Nov 2022
Reputation:
0
Ok, is this behavior possible with one switch?
The light is off
single click - the light turns on to the last brightness value
single click - the light turns off
hold - the light increases in brightness
hold again - the light decreases in brightness
Posts: 6,254
Threads: 806
Joined: Oct 2020
Reputation:
151
hold - the light increases in brightness
hold again - the light decreases in brightness
maybe you need multi times of "hold", you can test it.
Posts: 6,254
Threads: 806
Joined: Oct 2020
Reputation:
151
do you means, create some different HOLD ON trigger, send customsize protocol command to dimmer controller?
now "KCS" firmware not support this, but i will save your suggestion.
Posts: 23
Threads: 2
Joined: Nov 2022
Reputation:
0
I tried many different things...
Currently, it is not possible to get this behavior. Even creating multiple IFTTT commands.
single click - the light turns on to the last brightness value
single click - the light turns off
hold - the light increases in brightness
hold again - the light decreases in brightness
Will this be possible in the future?
Otherwise, the KCS system is not an option for me and I will need to use ESPHome and configure everything in home assistant.
I would prefer to use the KCS system because it works immediately after a power outage.
Thanks in advance!
Posts: 6,254
Threads: 806
Joined: Oct 2020
Reputation:
151
your requirements suggest use ESPHome config in yaml. ESPHome also work locally.