Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
KC868-H32B Pro
#1
I have a problem. I have KC868-H32B Pro, KC868-AK ESP32 Programmable Keyboard, KC868-HA V2. How to connect them together? In Home Assistant, KC868-H32B Pro works with MQTT normally, but I can't connect KC868-HA V2 additionally.
Reply
#2
KC868-AK connect to H32B Pro by RS232 cable directly, KC868-AK not need to use home assistant.
HAv2 can connect to your H32B Pro by RS485 cable directly, HAv2 not need to use home assistant.
Reply
#3
Ok, it works.


How to make KC868-HA v2 visible in HA?
Reply
#4
you can see this video tour: https://youtu.be/s5Htc43HqAc
Reply
#5
"Now I have a problem with the KC868-AK ESP32 Programmable Keyboard. When I press the button, it works like a momentary button (the relay turns on for a moment). Can you check the video?
When the Wifi Setting mode is enabled, there is such behavior in ESP32 development mode. When I turn it off, it works normally.

https://www.youtube.com/watch?v=mVFPB82LaKA
Reply
#6
do you have downloaded KCS firmware to AK or juse use original firmware.
if you are using original firmware, you need to config it before use, here is online guide: https://www.kincony.com/how-to-use-kc868...board.html
Reply
#7
I have one more question.
how to program KC868-H32B Pro to be visible in HA as ESP32?
Reply
#8
in H32B Pro ethernet config webpage, there is an option for RS485 type, just chose "special" . NOT chose "RTU".
Reply


Forum Jump:


Users browsing this thread: