[arduino code examples for G1]-04 RS485 communication test

[admin]

Code:

/*
* Made by KinCony IoT: https://www.kincony.com
*
* RS485 Communication Test
*
* This program is a simple test for RS485 communication using ESP32-S3.
* It will send a message over RS485 and then read incoming messages.
* The TXD pin is defined as GPIO 8 and RXD pin is defined as GPIO 18.
*/

#include <HardwareSerial.h>

// Define RS485 pins
#define RS485_RXD 18
#define RS485_TXD 8

// Create a hardware serial object
HardwareSerial rs485Serial(1);

void setup() {
  // Start serial communication for debugging
  Serial.begin(115200);
  while (!Serial);

  // Initialize RS485 Serial communication
  rs485Serial.begin(9600, SERIAL_8N1, RS485_RXD, RS485_TXD);
 
  Serial.println("RS485 Test Start");
}

void loop() {
  // Send a test message
  rs485Serial.println("Hello from KinCony G1!");

  // Wait for a short period
  delay(1000);

  // Check if data is available to read
  if (rs485Serial.available()) {
    String receivedMessage = "";
    while (rs485Serial.available()) {
      char c = rs485Serial.read();
      receivedMessage += c;
    }
    // Print the received message
    Serial.print("Received: ");
    Serial.println(receivedMessage);
  }

  // Wait before sending the next message
  delay(2000);
}

arduino ino file download: 

  4-RS485-Test.zip (Size: 760 bytes / Downloads: 17)
BIN file (you can use esp32 download tool download to ESP32-S3 with address 0x0 then directly to use) download: 

  4-RS485-Test.ino.merged.zip (Size: 184.54 KB / Downloads: 14)