RF doesnt show up?

[Borg357]

Greetings everyone New user here,

 I have a Board Model A16v3 - Software Version v3.9.1 Kincony relay using Home Assistant to control my devices (MQTT(HA)).

I learned in a few RF controls.  I used the Kincony A16V3 website to send the RF signals, which control my devices.

However, Home Assistant sees all the RF sensors, but doesn't see any of the RF controls??

Are there any other steps that I need to do to make the RF controls some into HA?

Thank you

-Richard

[admin]

download KCS v3 newest firmware: https://www.kincony.com/forum/showthread.php?tid=8796
how to use RF sender, here is KCS v3 online guide: https://www.kincony.com/how-to-use-kcsv3...board.html

[Borg357]

download KCS v3 newest firmware: https://www.kincony.com/forum/showthread.php?tid=8796
how to use RF sender, here is KCS v3 online guide: https://www.kincony.com/how-to-use-kcsv3...board.html

Will check into this. Thanks