01-25-2025, 03:33 PM
Hello,
After a modification via the web page of a parameter, the system says reboot in 5 seconds.
except that the system will never reboot, you always have to cut and reconnect the power supply.
It's exactly the same thing with the reset button..
Just ping the port and you can see that the card is not rebooted.
This is not normal.
I also noticed that after loading a firmware, the visible parameters (Example Modbus slave 1) are wrong.
Indeed it displays 1 but in fact it probably has another value because for it to be recognized as slave one you have to re-enter the value and save it, and then it works.
I test this product, I realize that it has no problems (see my posts) this is only on this card model or dear colleague have you seen this also on other card references?
I have the impression that the product is debugged by customers as bugs are found.
After a modification via the web page of a parameter, the system says reboot in 5 seconds.
except that the system will never reboot, you always have to cut and reconnect the power supply.
It's exactly the same thing with the reset button..
Just ping the port and you can see that the card is not rebooted.
This is not normal.
I also noticed that after loading a firmware, the visible parameters (Example Modbus slave 1) are wrong.
Indeed it displays 1 but in fact it probably has another value because for it to be recognized as slave one you have to re-enter the value and save it, and then it works.
I test this product, I realize that it has no problems (see my posts) this is only on this card model or dear colleague have you seen this also on other card references?
I have the impression that the product is debugged by customers as bugs are found.