m30 rs485 compatible energy meter

[kiloptero]

hi, i will purchase a m30
and want to know if a rs485 like this
Just found this amazing item on AliExpress. Check it out! CLP33.582 | 1P Energy Meter RS485 Modbus RTU Monitor Voltage Current Power Factor Frequency Toal Consumption
https://a.aliexpress.com/_mstTztE
its compatible and if the esphome yaml include this comunication
to see all the power di energy in 1 sensor!

[admin]

sure, you can integrate to esphome by modbus controller.

[kiloptero]

There is any diagram connection ? Thanks a lot. Any special configuration or the m30 just detect the modbus and receive the consume and present as an entity?
I see a config in the yaml

uart:
id: modbus_uart
rx_pin: 32
tx_pin: 33
baud_rate: 115200
stop_bits: 1
data_bits: 8
parity: NONE

[admin]

https://www.kincony.com/forum/showthread.php?tid=4089

[kiloptero]

thanks. im not an expert. and sorry for ask.. but with this https://shop.kincony.com/products/energy...3321597093 or https://shop.kincony.com/products/energy...3321629861 There is any special config in the yaml in esp home?

[admin]

see this video tour: https://youtu.be/1b9_oyCseCE

[kiloptero]

Great! but in my case I will use with the M30 and home assistant. Just connect the A and B port in the output of the RS485 to the RS485 ab in the m30? The config and esphome will do the rest? Thanks again!! Im waiting my first kincony product!

[admin]

where you home assistant installed? raspberry pi?

[kiloptero]

OPtiplex 7070 micro PC, but my idea is to connect to this rs485 with a m30.-

https://es.aliexpress.com/item/400046297...Redirect=y 

80AMP

[admin]

this is modbus energy meter, you can connect to your server's USB-RS485 port directly. or you can conenct to one kincony esp32 board's RS485 port. here is video tour:https://youtu.be/xEvOK3R12kc