A8S and Modbus sensor

[admin]

it's not easy to change address, you can try to open the sensor, there is a tiny PCB, if you can weld, you can change the i2c address.

[martinvysnovsky]

In your e-shop you write that the address should be editable. So is it?
https://shop.kincony.com/products/rs485-...e-by-sht30

[admin]

use PC software to config the RS485 address. after click "set" button, then power off the sensor and power on again.
   
PC software download: 
  Debug.zip (Size: 4.08 MB / Downloads: 25)

[martinvysnovsky]

Finally, it is working. Thank you very much.

For anyone else trying to set an address without the provided software. You should set the address to registry `0x0a`.

[admin]

ok, thanks share your result.