KC868-AG RF - sending repeated signals

[PhilW]

I'm new to this HW, so maybe I'm missing something.

I have a remote 433mhz that I "learned" on the Web UI.

When I transmit the signal, it is being sent around 5 times, triggering the receiving device to turn on and off and on again etc.
Basically, the device (ventilator) beeps when it gets a signal, and I'm hearing around 5 beeps.

Is there any way to configure this behavior?

Or should I flash the device with a different fimware? Can I just flash esphome on it - and hope to fix this somehow that way?

Current firmware: v2.2.4

[PhilW]

I guess I found it - "RF repeat count" in the system settings. I lowered it to 30. Looks like I can only set this globally, not per item.

I have not yet found a way to export the "learned" RF signals - I checked in MQTT, there was nothing other than a state. So I think I will try to flash ESPhome next.

[admin]

if you want customsize define every RF learned channel, use ESPHome is better.

[PhilW]

A bit off topic, but interestingly, when I use the learn & transmit functionality of the KCS firmware, it works. When I use ESPhome with either the data from the dumped RF log or using raw signals I got from FlipperZero, it does not work.

from the log:
[22:44:20][I][remote.drayton:236]: Received Drayton: address=0x7837 (0xf06e), channel=0x00c command=0x030

in esphome:

button:
- platform: template
name: Turn on Ceiling Fan
on_press:
- remote_transmitter.transmit_drayton:
address: '0x7837'
channel: '0x00c'
command: '0x030'

The investigation continues :-)