CT Clamp Compatibility

[admin]

"voltage" type CT sensor also can work.

[Stanb]

"voltage" type CT sensor also can work.

Hi,
I am back from vacation.
I will contact you via WhatsApp.

Just to recall:

1. I have YMDC SCT013 20A/1V class: 1(and 50A/1v).
   
2. I do not have problem with mini-jack plugs. I connect SCT's jack into the plug and then into the appropriate terminals of N30. I checked the connections and all works fine. This is not the problem. 
   
3. I tested the SCT on the wire of an electric kettle.
   I measured the current: 8.2A (voltage is 230V), but no readout in the logs of ESP32-generated firmware though. I measure the voltage on the terminals of N30. It swayed way beyond 1V.

Looking for help.

Stan

[admin]

3: you can download KCS v3 firmware, see MONITOR webpage to check current.