KC868-A6 Outputs

[petez69]

Hi Kincony

I have a relayboard that turns relay on when pin goes to GND.  I see A16 digital outputs go high when turned on....Can I invert this to make actuve GND ?

Thankyou..Peter

[admin]

it according to your arduino IDE code.

[petez69]

I am using homeassistant.....how should I configure the output in the YAML to drive the output to ground ?

Thankyou

[admin]

if you use home assistant, i think you are using ESPHome. just add "inverted: true" in your pins.
# Example configuration entry
switch:
- platform: gpio
pin:
number: 25
inverted: true

[petez69]

if you use home assistant, i think you are using ESPHome. just add "inverted: true" in your pins.
# Example configuration entry
switch:
  - platform: gpio
    pin:
      number: 25
      inverted: true

Hello

I dont have a circuit diagram for the v.5 A16 board.  I think you've set it up to turn the led on when the output goes to 12V.  I have just tried inverted: false and the LED doesnt work.  Can you please share the circuit diagram so I can have a look...

Thankyou

[admin]

https://www.kincony.com/download/KC868-A...ematic.pdf