KC868-AG - Tasmota firmware - cant read ir remote data

[ADLER LINHARES]

Hello folks,
i am facing a problem with my KC868-AG and I would apreciate some help.
first of all i am a noob on tasmota subject so probaly my poor knowledge should be the reason that i dont get result.

as stated in the body of the message, I recently acquired a KC868-AG. As soon as I opened the package, I performed the recording of the tasmota through the link below:

https://tasmota.github.io/install/


image 01 - tasmota
   


after completing the previous step, went to the following path: CONFIGURATION > CONFIGURE OTHER

and insert the following template:
{"NAME":"KC868-AG","GPIO":[0,0,1056,0,480,0,0,0,0,0,1,0,1,1,1,1,0,1,1120,1152,0,7968,0,0,0,0,0,0,1,1,1,1,1,0,0,1],"FLAG":0,"BASE":1,"CMND":"BuzzerPwm 1"}
as in kincony site - template

image 02
   

after that i have no idea how to read te code of a ir remote control of mine.

when i go to console I can see only this :

image 03 - tasmota console
   

Is there a way to read the remote control IR signal through the console?
Is there a command model in order to modulate the signal?

Best regards,

[admin]

hello, i have downloaded this tasmota firmware to KC868-AG. when use Mitsubishi air conditioner remoter, you can see that is feedback IR message.

  tasmota32-ir.zip (Size: 854.45 KB / Downloads: 195)