ESP32 RF

[Wojtek]

I downloaded 2 files from this topic: bootloader.zip and partition-table.zip. Where can I find the third file? how to create it?
Uploading only 2 files didn't stop rebooting.
Should I find another factory file from the esp32 manufacturer on the Internet?

[admin]

third is your own BIN file, it's user BIN. you compiled by arduino IDE. Do you understand?

[Wojtek]

Ok, I created a third file on the Arduino IDE, detected and changed the 6 keycode 433 in my file, exported the compatible binary in the Arduino IDE, flashed the 3 files to esp32 on the server using espressif flash_download_tool. ESP32 does not restart - it's OK. But pressing buttons on the remote doesn't toggling the light.
Is my code in the file written correctly:

  Przełączanie 1-6 znane kody - Kopia.txt (Size: 1.88 KB / Downloads: 191)

[admin]

if you use arduino IDE download to ESP32 , this code whether work well?

[Wojtek]

What does the code work fine? When I have the Arduino IDE running, then using the Serial Monitor function, I see that the esp32 in Kincony Server detects pressing the RF 433 remote control. But it does not affect the on / off light / relay.

[admin]

do you have replaced keycode? every remote have different keycode.
if you can see keycode output value in arduino IDE Serial Monitor, just replace control relay ON/OFF code. if you can't see the keycode when you pressed 433M remote, that's have another problem.

[Wojtek]

Yes, i replaced keycode. I see keycode on IDE Serial Monitor when i pressed 433M remote, but relay didn't toggle.

[admin]

i have tested code, sorry for my before error photo.
just set serial1 pin define as these will be work fine. here is photo.

#ifndef RX1
#define RX1 16
#endif

#ifndef TX1
#define TX1 17
#endif



if you want to eraser all esp32 data, you can use ESP Tool: https://www.kincony.com/esp-module-flash...tools.html

see this photo, config the serial port in arduino config file. will be work fine.

[Wojtek]

I set this RX 1 and TX1, make new .BIN file in Arduino IDE, flash 3 file and now don't detect keycode ind serial monitor and switch don't toggle.

[admin]

first step, you need let serial monitor can output keycode when remote button pressed. this step never work?