Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
KC868 COLB MINI
#1
I have a device KC868 COLB MINI , i try to configure this by connecting power source and ethernet but i didn't find any ip address in the ip scanner and i dont have any response from the device side.... please help me to configure this
Reply
#2
feedbacked to you by whatsapp. maybe your power polar is wrong.
Reply
#3
in KC868 COLB MINI controller i have connected both the power and ethernet cables, and switch it into ethernet mode but i didn't get any ip address by the ip scanner... please help...
Reply
#4
KC868-COLB and your computer all connect to same router, MUST in same network.
Reply
#5
(03-13-2023, 12:33 PM)admin Wrote: KC868-COLB and your computer all connect to same router, MUST in same network.

already connected in same network only...
Reply
#6
take some photos let me have a look is better. maybe your scan device tool have not chose the correct network card.
Reply
#7
(03-13-2023, 10:43 PM)admin Wrote: take some photos let me have a look is better. maybe your scan device tool have not chose the correct network card.


Attached Files Image(s)
       
Reply
#8
e.) Hold on Ethenret mode button, when the [yellow and white and blue LED] all is ON, release it, then work mode in “TCP Server” and IP (192.168.1.200) by static mode;

Note: after changed mode, the controller will restart automatically.

The controller default work mode is DHCP and TCP Server mode.

here have details: https://www.kincony.com/how-to-use-kc868...oller.html

you can use kincony scan device tool to find out controller ip.
https://www.kincony.com/download/KinCony...Device.zip
Reply
#9
can i control the water float sensor with kc868 colb mini?plz guide me
Reply
#10
what's means of "control" ? read sensor data or control a relay?
Reply


Forum Jump:


Users browsing this thread: