K868-A16 433 RF MHz receiver

[admin]

see these images. Do you will install on KC868-A16 board?
   
   

[Olsen@HuaHin]

I will install on KC868-A16 board as I got it from you guys.
Which antenna is for sender long or short one?

[admin]

long is "sender".

[Olsen@HuaHin]

Thank you for prompt reply! 

[admin]

you are welcome.

[MnM]

Hi have installed the send/receive antennas and the modules in my kincony device.
I have not added and configuration for these. However, what I have found is that after I installed the modules it kills my home garage remote. The home garage remote only works when i very close proxymity of the garage door motor (like 12 meters). Anything outside of this range it doesnt work anymore.
If I cut power to the kincony device it works normal again.

So I am wondering if there is any ESPHome configuration to adjust the power of the RF modules?

Thanks

[admin]

do you use ESPHome or KCS firmware? if you are using ESPHome. maybe you have config the yaml always send RF signal.