Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
TC100 sensor
#1
Hello,
I want to connect a TC 100 sensor on an analog port. How to caliber the result to get the right temperature (instead of value like "650")?
I am using KCS.
Thanks
Reply
#2
do you have TC100 PDF datasheet file? what's signal output?
Reply
#3
Here is the doc.thanks


Attached Files
.pdf   DocTechniqueTC100.pdf (Size: 67.69 KB / Downloads: 290)
Reply
#4
because our board input range is dc 0-5v, i see your pdf have showed 3 voltage with temperature. i am not sure when your sensor 0-5v means whtat temperature range. you can test, if really hard to use, just replace with DS18B20 is easy to use. we will release new "KCS" V2 soon.
Reply


Forum Jump:


Users browsing this thread:
1 Guest(s)