KC868-COLB V1.8 new firmware for MQTT update

[admin]

improvement:

1. KC868-COLB default set "enable" for  auto upload function, before version default is "disable".
2. Fixed problem that if have a DS18B20 temperature value auto loaded, other temperature sensors will stop upload, until temperature value changed will auto upload again. Now all DS18B20 temperature sensor will all auto upload.
3. Support use MQTT function by ethernet. it will easy integrate to third-party software, like home assistant, details see our tour: https://www.kincony.com/knowledge/home-assistant


KC868-COLB V1.8 firmware download:
download the ZIP file , unzip update the bin file for KC868-COLB logical controller.

  AD_COLB_V1_1_8_210419.zip (Size: 41.58 KB / Downloads: 415)

[papakigr]

after update i get wrong user/pass.

I tried to erase cookies etc, but no luck.

Also tried from other browser.

After i changed the ethernet mode back and forth.

[admin]

after update, default user and password will be:
user: admin password:admin