Smart Home Automation Forum › Technical Support › KC868-A8 v
CT Clamp

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
CT Clamp
milan.net Offline
Junior Member
**
Posts: 17
Threads: 4
Joined: Aug 2023
Reputation: 0
#1
08-23-2023, 12:02 PM (This post was last modified: 08-23-2023, 12:10 PM by milan.net.)
Hi, I would like to as for help connecting a SCT013 10A CT clamp to one of the analog inputs.

Thank you for help
Find
Reply
admin Offline
Administrator
*******
Posts: 6,348
Threads: 811
Joined: Oct 2020
Reputation: 157
#2
08-23-2023, 12:12 PM
CT clamp should connect to KC868-M16 or M16v2 board.
KC868-A8 not have level convert circuit.
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://kincony.aliexpress.com
Find
Reply
milan.net Offline
Junior Member
**
Posts: 17
Threads: 4
Joined: Aug 2023
Reputation: 0
#3
08-23-2023, 01:48 PM
(08-23-2023, 12:12 PM)admin Wrote: CT clamp should connect to KC868-M16 or M16v2 board.
KC868-A8 not have level convert circuit.

Would it be possible to use external level covert circuit? And use vcc from temp sensor connector?i
Find
Reply
admin Offline
Administrator
*******
Posts: 6,348
Threads: 811
Joined: Oct 2020
Reputation: 157
#4
08-23-2023, 11:09 PM
the CT sensor is output dc 0-1v signal, it's a little small, you can try to connect to ADC 0-5v channel, but i think the value will not be too precise.
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://kincony.aliexpress.com
Find
Reply


Forum Jump:


Users browsing this thread: