KC868-H32B V4.29 new firmware update

[uvrtar]

Hi,

I also get wrong username and password error, when I try to update firmware on 4.29. Bootloader and everything went ok, I get the web page of the controller (admin/admin does not work), also all the switch terminal board inputs work.
Also I noticed when I try to switch the relays with my previeos configuration in Node-Red, that the controller is very slow, and responds to commands with a delay or does not respond at all.

With 4.20 fw all worked ok. Every week or so I had to reset the controller, because it did not respond on my commands - switch terminal board commands and HA(node red) commands.

[admin]

if you updated newest firmware, we suggest integrate to HA with MQTT, it's very stable, not need to use Node-Red work with HA. only HA is enough.

[uvrtar]

I will do that.

But what about the password error and about the controller not responding?

thank you.

[admin]

after update to newest verison, user name and password all default set to "admin" , "admin".

[uvrtar]

After update to 4.29

[mirko]

In my case didn't work admin/admin also after an update. I had to reset to default settings.

[admin]

new firmware use ethernet button for reset will set user name and password to "admin" - "admin"

[uvrtar]

Ok, thank you.

What is the correct procedure for reset, and could you point me to the correct button for the reset.

Thank you.

[admin]

Hold on "Ethernet Mode" button, when the [yellow and white LED] all is ON, release it, then work mode in “UDP” and IP by DHCP mode and password reset to "admin". user name fixed by "admin", never changed.

[uvrtar]

OK, now after reset it is working.
Thank you.