12-08-2023, 12:52 PM
SORRY! the board is all good. working completely fine. It was the Extend Relay's manual switch which were turned on.
But i am currently facing flashing issue in this A16 board.
I was able to flash this same board earlier once with esphome and next time with Firmware too when you asked to check.
but now when i am trying to flash it back once again with esphome it doesnt seem to be available for flashing. i tried tasmotizer to flash legacy format of esphome into this A16 board but it shows error while flashing.
i also tried the modern format from web.esphome.io where i get error showing "failed to initialize, Please press the boot button".
But i am currently facing flashing issue in this A16 board.
I was able to flash this same board earlier once with esphome and next time with Firmware too when you asked to check.
but now when i am trying to flash it back once again with esphome it doesnt seem to be available for flashing. i tried tasmotizer to flash legacy format of esphome into this A16 board but it shows error while flashing.
i also tried the modern format from web.esphome.io where i get error showing "failed to initialize, Please press the boot button".