Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
lost access to my module’s interface with IP address
#5
(01-01-2024, 01:59 AM)admin Wrote: after downloaded KCS firmware, MUST re power on of your KC868-A16S board.
your PC and A16S must connect to same router in one local network.

The KCS firmware is well installed and working. I normally connect to the interface with the IP address. However, after configuring the A16S module on ESPHome with YAML, although Home Assistant is working well, I can’t connect to my module with the IP address. I have restarted and both the module and my PC are connected to the same router (network).”
Reply


Messages In This Thread
RE: lost access to my module’s interface with IP address - by Lamri - 01-01-2024, 10:46 PM

Forum Jump:


Users browsing this thread: