01-15-2024, 10:32 PM
Hello,
I have an A8S card.
This card has an buzzer or beep at GPIO 2
I have a software that search for a valid wifi, using wifi events. After each disconnection it will try the next available wifi until it can get an ip. Sometimes there is no wifi at all and the system loop for ever.
The use of pin 2 seams to have a conflict with the wifi.
When the system loop the beep turn on, even I switch it to off.
Is that any means to switch off the beep ?
I can provide code if this is needed
Many thanks for your help.
Best regards
Thierry
I have an A8S card.
This card has an buzzer or beep at GPIO 2
I have a software that search for a valid wifi, using wifi events. After each disconnection it will try the next available wifi until it can get an ip. Sometimes there is no wifi at all and the system loop for ever.
The use of pin 2 seams to have a conflict with the wifi.
When the system loop the beep turn on, even I switch it to off.
Is that any means to switch off the beep ?
I can provide code if this is needed
Many thanks for your help.
Best regards
Thierry