03-17-2024, 07:26 PM
(This post was last modified: 03-17-2024, 08:13 PM by iwzr.
Edit Reason: update image links
)
I had to set the project on hold for a while, but now I am on track again. I have the same dongle as you suggested and also the same software, but I still get the error:
![[Image: chipset.png]](https://i.postimg.cc/R05dgZYK/chipset.png)
![[Image: connection.png]](https://i.postimg.cc/QCyk185B/connection.png)
What am I doing wrong? I hope I did not brick my device.
Code:
Hardware configuration set to <ST-LINK on USB with STM32F103x8 plugged in and SWD protocol>.
Blank check before programming (when available) is OFF
Verify after programming is ON.
Clear memory before loading a file is ON.
Erase device memory before programming (when available) is ON.
Display a popup window when an error occurs is ON.
Log activity is OFF
> Loading file C:\usr\Local_Work\NET_IAP_DIMMER8_0909.hex in PROGRAM MEMORY area ...
< File successfully loaded. File Checksum 0x1909E8
> Programming OPTION BYTE area...
Error : Wrong device selected ! Check the configuration or the device !
Error : < OPTION BYTE programming failed.What am I doing wrong? I hope I did not brick my device.