On DI 4 I have connected a push button....with this configuration it is working fine.
The problem is when put a new condition in IFTTT to be: when DI 1 is TRUE "AND" I pres on RF1 on remote , the DO1 is ON, ......... BUT IF DI 1 IS FALSE AND I PRESS ON RF1 ON REMOTE, THE DO1 SHOULD NOT BE ON , because Di1 + RF1 don't meet both conditions .
Please test : put a condition True on DI 1 + RF 1 activate DO 1. ( For sure it is working). Electrical it is like this : negative on DI 1 + RF 1= Do 1.
Now disconnect negative wire from DI1 and then press RF 1, should not activate DO1 ....but it is activate....seems don't care if DI 1 is true or not.
This is the problem.
Regards
The problem is when put a new condition in IFTTT to be: when DI 1 is TRUE "AND" I pres on RF1 on remote , the DO1 is ON, ......... BUT IF DI 1 IS FALSE AND I PRESS ON RF1 ON REMOTE, THE DO1 SHOULD NOT BE ON , because Di1 + RF1 don't meet both conditions .
Please test : put a condition True on DI 1 + RF 1 activate DO 1. ( For sure it is working). Electrical it is like this : negative on DI 1 + RF 1= Do 1.
Now disconnect negative wire from DI1 and then press RF 1, should not activate DO1 ....but it is activate....seems don't care if DI 1 is true or not.
This is the problem.
Regards