04-24-2024, 08:42 PM
(04-23-2024, 11:50 PM)admin Wrote: i have said, take a whole video to whatsapp. I don't know the details, I can't make a judgment.
I researched this error and its been seen by other Kincony board owners.
I downloaded the Tasmota32 13.4.0 from Git hub and it loads just fine. This shows that the board is working, the flash tool is working. However, as expected, the firmware does not support
some of your features.
The error shown in my previous email seems associated with ESPHome.
I watched the video but it does not use the 2.2.2. firmware on your site, it uses a much earlier version.
I just need to know what base firmware is needed for this board and where to find it. A video is not going to help us here.
My other KC 868-A6 units are working with the Tasmota32 also but as with the A8, the firmware does not support the features
PLEASE PROVIDE:
1. ANY OPERATING FIRMWARE (IF ANY) THAT NEEDS TO BE LOAD ON THE KC868-A8 TO SUPPORT THE KINCONY 868-A8 FIRMWARE LOAD AND THE LINK
2. TO BE CERTAIN I HAVE THE CORRECT VERSION, PLEASE PROVIDE THE LINK TO THE RECOMMENDED KINCONY FIRMWARE (E.G.2.2.2) FOR THE 868-A8 VERSION 1.5 BOARD, AND THE LINK
3. PLEASE PROVIDE THE LINK TO THE RECOMMENDED KINCONY TASMOTA FIRMWARE AND THE LINK
I FOLLOWED YOUR VIDEO AND IT DOES NOT WORK FOR THIS BOARD AS IT STANDS. WHEN IT IS SHIPPED, CAN YOU TELL ME WHAT, IF ANY, FIRMWARE KINCONY LOADS? PERHAPS IT'S BEEN CORRUPTED
I REALLY WANT TO USE YOUR PRODUCTS BUT WITHOUT SUPPORT THIS WILL NOT WORK. I AM RUNNING LOTS OF ESP32 DEV BOARDS WITH NO ISSUES.