Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Unable to receive IR signals using ESPHome
#3
(05-08-2024, 11:59 AM)admin Wrote: This is RAW code, because there are many signal on air. you should dump ALL signal.
you can check ESPHome config by this link: https://esphome.io/components/remote_receiver.html

here is KC868-AG work with IR device video tour, this will help you:
https://www.kincony.com/forum/showthread.php?tid=1812

Thank you for the reply BUT:
a) still waitinf for the ok if my esphome yaml configuration is right or not (do you confirm the IR receiver part is ok?)
b) the video does not show IR receiving but IR sending. i already have my device working with IR sending to daikin or mitsubishi, but it does not receive/dump any daikin or mitsubishi remote control IR codes. that's the problem!
Reply


Messages In This Thread
RE: Unable to receive IR signals using ESPHome - by pscaffardi - 05-08-2024, 12:54 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)