Hi Kincony,
Received my D16 controller and finally got to test it. It seems to work with any 433MHz remote I have, easy to follow your "how to use" page to get it going. Great stuff.
I have noticed that "hold to adjust dimmer level" only works with hard wired switches? With remotes it just switches light on or off (mind you I don't have lights connected yet, only looking at the debug window output).
I really need this to fully work on remotes, based on your description on Aliexpress it sounds like it should adjust equally on wired and wireless...Can you comment please, any setting or anything I need to do to get this wot work?
Would you consider patching firmware to act on RF signals in a similar way as dry contacts, using maybe timer to track subsequent quick signals interpreting them as "hold"?
Alternatively I could use ESP32-S3 with RF receiver and write my own software to control D16 over RS485, but would really prefer if D16 supported dimming by "hold" function via RF.
Thanks!
Received my D16 controller and finally got to test it. It seems to work with any 433MHz remote I have, easy to follow your "how to use" page to get it going. Great stuff.
I have noticed that "hold to adjust dimmer level" only works with hard wired switches? With remotes it just switches light on or off (mind you I don't have lights connected yet, only looking at the debug window output).
I really need this to fully work on remotes, based on your description on Aliexpress it sounds like it should adjust equally on wired and wireless...Can you comment please, any setting or anything I need to do to get this wot work?
Would you consider patching firmware to act on RF signals in a similar way as dry contacts, using maybe timer to track subsequent quick signals interpreting them as "hold"?
Alternatively I could use ESP32-S3 with RF receiver and write my own software to control D16 over RS485, but would really prefer if D16 supported dimming by "hold" function via RF.
Thanks!