I have an A16 board, it has firmware KCS_KC868_A16_V2.2.2.bin and I would like to set up communication with Home Assistant (HA).
In A16 I set the values for HA in Protocol > General > MQTT (see image). Mqtt communication can be seen in green in the Monitor.
In HA, should I add settings for communication to ESPHome or MQTT to configuration.yaml?
If I use the code according to https://www.kincony.com/kc868-a16-ethern...igure.html (and change the IP address) or according to https://www.kincony.com/forum/attachment .php?aid=753 etc. so checking the file shows many errors like "duplicate key" etc.
Please can you share the full code (for all inputs, outputs, senzroy and RF signals) to put in the configuration.yaml?
In A16 I set the values for HA in Protocol > General > MQTT (see image). Mqtt communication can be seen in green in the Monitor.
In HA, should I add settings for communication to ESPHome or MQTT to configuration.yaml?
If I use the code according to https://www.kincony.com/kc868-a16-ethern...igure.html (and change the IP address) or according to https://www.kincony.com/forum/attachment .php?aid=753 etc. so checking the file shows many errors like "duplicate key" etc.
Please can you share the full code (for all inputs, outputs, senzroy and RF signals) to put in the configuration.yaml?