How to get started

[jarekD]

Ehh, ok, finally figured this out, so I'll write a quick summary - hopefully someone will find it useful.

Brand new board, first power up:

1) Downloads:
USB driver firstly: https://www.kincony.com/download/CH341SER.zip
Firmware flash tool: https://www.kincony.com/wp-content/uploa..._3.9.2.zip
Latest firmware: https://www.kincony.com/forum/showthread.php?tid=3791

2) Install USB serial driver

3) Prepare board: if you have radio transmitter and received - remove it
Connect USB cable
Connect 12V power

4) Flash the firmware according to instructions:
https://www.kincony.com/esp32-kcsv2-firmware.html

5) Power down, power up the board. Clicking the reset button is NOT enough.

6) For me, after these steps, finally the AP appeared on list of WiFi networks and I could connect to http://192.168.4.1