Smart Home Automation Forum › Technical Support › KinCony Server-Mini / Server-16 Raspberry Pi4 relay module
Rs485

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Rs485
Savino Offline
Junior Member
**
Posts: 23
Threads: 7
Joined: Oct 2023
Reputation: 0
#9
06-28-2024, 06:33 PM
(06-27-2024, 10:31 PM)admin Wrote: if you are first time to use server-mini,  you need to enable serial port for CM4, here is details :
https://www.kincony.com/forum/showthread.php?tid=1971

and please...what about the slave side?
My slave board is kc868-A6, could you post the basic line to add to the A6 yaml file in order to enable and setup Modbus-RTU protocol?
Find
Reply


Messages In This Thread
Rs485 - by Savino - 05-23-2024, 04:07 AM
RE: Rs485 - by admin - 05-23-2024, 05:54 AM
RE: Rs485 - by Savino - 05-26-2024, 06:46 AM
RE: Rs485 - by admin - 05-26-2024, 06:51 AM
RE: Rs485 - by Savino - 06-27-2024, 05:01 PM
RE: Rs485 - by Savino - 05-26-2024, 04:49 PM
RE: Rs485 - by admin - 05-26-2024, 11:46 PM
RE: Rs485 - by admin - 06-27-2024, 10:31 PM
RE: Rs485 - by Savino - 06-28-2024, 06:33 PM
RE: Rs485 - by Savino - 07-07-2024, 08:17 PM
RE: Rs485 - by admin - 06-29-2024, 01:34 AM
RE: Rs485 - by Savino - 06-29-2024, 02:48 PM
RE: Rs485 - by admin - 06-29-2024, 11:51 PM
RE: Rs485 - by admin - 07-07-2024, 11:13 PM
RE: Rs485 - by Savino - 07-08-2024, 06:57 AM
RE: Rs485 - by admin - 07-08-2024, 07:39 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)