V2.2.2 will not flash anymore

[Philadam]

Here is a picture of my board. Don't know what good it will do.
See post: https://www.kincony.com/forum/showthread...4#pid14604

V2.2.2 was working on this board in the past, but now it will not function after flashing.

ESPHOME and V2.1.9 both work just fine. Something on this board has changed that is preventing v2.2.2 or > from being detected after flashing.

The ESP log I sent you shows that ethernet is not functioning.

V2.1.9 log:

[17:14:17]I (2698) eth: Ethernet Started
[17:14:17]I (2699) eth: Ethernet init
[17:14:17]I (2699) wifi station: ESP_WIFI_INIT
[17:14:17]I (2700) eth: Set static ip:192.168.3.60,netmask:255.255.255.0,gateway:192.168.3.1
[17:14:17]I (2708) eth: Ethernet Link Up
[17:14:17]I (2711) eth: Ethernet HW Addr 90:38:0c:a3:be:43
[17:14:17]I (2716) esp_netif_handlers: eth ip: 192.168.3.60, mask: 255.255.255.0, gw: 192.168.3.1
[17:14:17]I (2725) eth: Ethernet Got IP Address
[17:14:17]I (2729) eth: ~~~~~~~~~~~
[17:14:17]I (2733) eth: ETHIP:192.168.3.60
[17:14:17]I (2736) eth: ETHMASK:255.255.255.0
[17:14:17]I (2741) eth: ETHGW:192.168.3.1

The above highlighted lines are from the v2.1.9 log , but are missing in the v2.2.2 log.

V2.2.2 log:
[17:15:33]I (2700) eth: Ethernet Started
[17:15:33]I (2701) eth: Ethernet init
[17:15:33]I (2701) wifi station: ESP_WIFI_INIT
[17:15:33]I (2702) eth: Ethernet Link Up
[17:15:33]I (2705) eth: Ethernet HW Addr 90:38:0c:a3:be:43