Yes. I always power off/on after I flash.
This is getting frustrating.
I have gone back and tried every version from 1.0.24 to 2.2.4. If they are a fresh copy from your site, they flash but cannot be detected.
If I flash from a previous copy that I saved via the esptool where I was able to detect and set the IP address for my network, they work.
The only thing that has changed in the interim is that I flashed it with an ESPHOME configuration from esphome version 2024.6.4
It is after that that your version of the firmware flashes but are unable to be detected.
This is getting frustrating.
I have gone back and tried every version from 1.0.24 to 2.2.4. If they are a fresh copy from your site, they flash but cannot be detected.
If I flash from a previous copy that I saved via the esptool where I was able to detect and set the IP address for my network, they work.
The only thing that has changed in the interim is that I flashed it with an ESPHOME configuration from esphome version 2024.6.4
It is after that that your version of the firmware flashes but are unable to be detected.