How can I toggle E16S relays from digital inputs on different E16S boards? There are two solution:
A. download KCS firmware, then create IFTTT command, let controller A's digital input trigger controller B's Relay by network custom protocol or RS485 command. if you also want use home assistant, let KC868-E16S integrate to home assistant by MQTT.
B. let your all controller integrate to Node-Red by MQTT. Then you can config any controller's INPUT trigger any controller's OUTPUT. this way just use Node-Red as a bridge.
solution A is let two controller work directly without any other software.
A. download KCS firmware, then create IFTTT command, let controller A's digital input trigger controller B's Relay by network custom protocol or RS485 command. if you also want use home assistant, let KC868-E16S integrate to home assistant by MQTT.
B. let your all controller integrate to Node-Red by MQTT. Then you can config any controller's INPUT trigger any controller's OUTPUT. this way just use Node-Red as a bridge.
solution A is let two controller work directly without any other software.