08-08-2024, 07:42 PM
Hi everyone,
I’m looking for some advice on the KC868-A16 board. I want to know if it is compatible with a 433 MHz Superheterodyne RF module. Previously, I had issues with signal range using common 433 MHz RF modules, so I bought the Superheterodyne module to test it. However, when I tried using it with a 433 MHz alarm sensor, it didn’t detect the signal when I attempted to learn it using the KCS firmware.
I’m fairly new to this and just started experimenting with this board today. I also haven’t soldered the antenna to the RF module yet, but I was testing the sensor right next to the module.
Has anyone had experience with this setup or could offer any insights?
Thanks in advance!
I’m looking for some advice on the KC868-A16 board. I want to know if it is compatible with a 433 MHz Superheterodyne RF module. Previously, I had issues with signal range using common 433 MHz RF modules, so I bought the Superheterodyne module to test it. However, when I tried using it with a 433 MHz alarm sensor, it didn’t detect the signal when I attempted to learn it using the KCS firmware.
I’m fairly new to this and just started experimenting with this board today. I also haven’t soldered the antenna to the RF module yet, but I was testing the sensor right next to the module.
Has anyone had experience with this setup or could offer any insights?
Thanks in advance!