Hello everyone,
I recently purchased a KC868-A16 Rev:1.6 board. I've installed the USB driver, downloaded the latest firmware, and the corresponding download tool. However, when I try to upload the firmware, I encounter an error with the following message: "Error 2-Sync Fail."
The error message suggests checking the chip datasheet to confirm that the strapping pins' status is correct. I’ve attached a screenshot of the error for reference.
Here’s a brief overview of what I’ve done so far:
Could anyone provide guidance on resolving this issue? Any tips or steps to ensure the strapping pins are correctly configured would be greatly appreciated.
Thank you in advance for your help!
Best regards,
Matheus
I recently purchased a KC868-A16 Rev:1.6 board. I've installed the USB driver, downloaded the latest firmware, and the corresponding download tool. However, when I try to upload the firmware, I encounter an error with the following message: "Error 2-Sync Fail."
The error message suggests checking the chip datasheet to confirm that the strapping pins' status is correct. I’ve attached a screenshot of the error for reference.
Here’s a brief overview of what I’ve done so far:
- Installed the USB driver for the board.
- Downloaded the latest firmware and download tool.
- Attempted to upload the firmware, which resulted in the error message.
Could anyone provide guidance on resolving this issue? Any tips or steps to ensure the strapping pins are correctly configured would be greatly appreciated.
Thank you in advance for your help!
Best regards,
Matheus