09-11-2024, 09:40 AM
Hello, I am only a beginner and have problems with interrupt.
I have KC868-A8 V1.5 and use PCF8574.
The program runs OK, but for the security of the project I need to watch that 1 parameter measured with an analog tool, stops the whole sketch at avery moment when the parameter is to high.
Is it possible with my Kincony?
Can somebody help with the code?
Kind regards
I have KC868-A8 V1.5 and use PCF8574.
The program runs OK, but for the security of the project I need to watch that 1 parameter measured with an analog tool, stops the whole sketch at avery moment when the parameter is to high.
Is it possible with my Kincony?
Can somebody help with the code?
Kind regards