09-13-2024, 02:02 AM
(This post was last modified: 09-13-2024, 02:33 AM by telewizard13.)
The 5V and 3.3V voltages were all normal. I covered the surrounding circuitry with Kapton tape and used my hot air station to remove the faulty ESP chip. I ordered a ESP32-WROOM-32UE-N8 8mB chip from Mouser. Hopefully that is the correct one. It should arrive next week. I'll have to re-flash it and load the firmware again. Hopefully that will resolve the issue.
Now I'm concerned I ordered the wrong part from Mouser. Which version of the ESP32 is the correct one? It isn't marked on the part or in your spec sheet.
Now I'm concerned I ordered the wrong part from Mouser. Which version of the ESP32 is the correct one? It isn't marked on the part or in your spec sheet.