09-18-2024, 12:36 AM
(08-31-2024, 06:46 PM)frozendevl Wrote: Hello, my KC868-M16v2 arrived yesterday (great product!) and I was able to get it updated through ESPHome and connected to Home Assistant without issue. However, I'm in the US and (1) have a few 220V devices that I would like to measure, meaning I need to combine two of the CT Clamp sensors into a single value in Home Assistant for power monitoring and (2) would like to measure the input of power coming from the meter on the first two clamps. How would I go about updating the ESP YAML to achieve this so that it can display accurately in Home Assistant Energy?
now if you use one CT clamp sensor, what value showed? what correct value should show?